Research Article
Open Access Peer-reviewed

Elaboration of Porous Geopolymer Cement from Sangaré Clay and Shell Egg Powder: Application as Thermal Insulation

Jeanne Atchana1, 2,, Paul Nestor Djomou Djonga1, Benoit Loura2, Valery Gomdje Hambate3, Jean Bosco Tchatchueng4

1Department of Chemistry, Faculty of Science, University of Maroua, P.O. Box 46 Maroua, Cameroon

2Department of Refining and Petrochemistry, P.O. Box 08, University of Maroua, Kaele Cameroon

3Departement of Textile and Leather Engineering, National Advanced School of Engineering of Maroua, University of Maroua, P.O. Box 46 Maroua, Cameroon

4Department of Applied Chemistry, National Advanced School of Agro Industrial Food, University of Ngaoundere, P.O. Box 455Ngaoundere, Cameroon

American Journal of Materials Engineering and Technology. 2021, 9(1), 21-30. DOI: 10.12691/materials-9-1-2
Received September 10, 2021; Revised October 14, 2021; Accepted October 24, 2021

Abstract

This study focuses on the preparation of porous geopolymer cements for thermal insulation applications using commercial calcium carbonate and low-value calcium carbonate-rich waste such as eggshell powders as pore-forming agents. The control and porous geopolymer cements were prepared by adding phosphoric acid (4M) as a chemical ingredient to metakaolin containing 0 and 10 wt% of the foaming agent. Results showed that Sangare clay is sandy with a few silts and traces of gravel. Diffractogram of the clay indicates the presence of: Kaolinite (Kao); Illite (Ill); Quartz (Qz) and Potassium Feldspars (Fds). This was confirmed by the Infrared spectrum of the material where bands characteristic of the presence of kaolinite (3689-3649 cm -1) and of other minerals have been found. Characterization of eggshell powder shows that the source of calcium consists mainly of CaCO3. The apparent densities of geopolymer cement obtained decreased when the aluminosilicate materials (metakaolin) are replaced by proportions of eggshell powders and commercial calcium carbonate (0, 1, 3, 5, 7 and 10%). It was also observed that the compressive strengths of geopolymer cements based on eggshells are greater than those based on commercial calcium carbonate and the thermal conductivity decreases with the increase of the porogen. These results corroborates with that of the apparent density and compressive strength which decreases with the increase of the porogen. Results shows that geopolymer cements obtained have accumulated high pores in their structures. The values of thermal conductivity of the control and porous geopolymer cement from eggshell ranges between 0.10 and 0.17 W/mK, respectively. It was concluded that the low-value calcium carbonate-rich wastes (egg shell) could be used for producing porous geopolymer cements which could be utilized for thermal insulation applications.

Keywords:

Sangaré clay, egg shell, thermal insulator and porous geopolymers
[1]  Davidovits J. Geopolymer Chemistry and Applications. Third edition, Geopolymer Institute, Saint-Quentin, France (2011) 612.
 
[2]  Wagh AS Chemistry bonded phosphate ceramics-a novel class of geopolymers. Ceramics Transactions 165 (2005) 1007-116.
 
[3]  Cao H., Zhang L., Zheng H., Wang Z. Hydroxyapatite nanocrystals for biomedical applications. The Journal of Physical Chemistry C 114 (2010) 18352-18357.View Article
 
[4]  Tchakouté, KH, Rüscher, CH, Kamseu, E., Djobo, JNY, Leonelli, C. The influence of gibbsite in kaolin and the formation of berlinite on the properties of métakaolin phosphate-based geopolymer cements. MaterialsChemistry and Physics 199 (2017).View Article
 
[5]  Zhang ZH, Zhu HJ, Zhou CH, Wang H. Geopolymer from kaolin in China: An overview. Applied Clay Science 119 (2015) 31-41.View Article
 
[6]  Ge Y., Yuan Y., Wangliu K. et al. Preparation of geopolymer-based inorganic membrane for removing Ni2 + from wastewater. Journal of HazardousMaterials 299 (2015) 711-718.View Article  PubMed
 
[7]  Bai C., Franchin G., Elsayed H., Zaggia A., Conte L., Li H., Colombo P. High-porosity geopolymer foams with tailored porosity for thermal insulation and wastewater treatment. Journal of Materials Research 32 (2017) 3251-3259.View Article
 
[8]  Strini A., Roviello G., Ricciotti L., Ferone C., Messina F., Schiavi F., Corsaro D., Cioffi R. TiO 2 -based photocatalyticgeopolymers for nitric oxide degradation. Materials 9 (2016) 513p.View Article  PubMed
 
[9]  Okada K., Imase A., Isobe T., Nakajima A. Capillary rise properties of porous geopolymers prepared by an extrusion method using polylactic acid (PLA) fibers as the pore formers. Journal of the EuropeanCeramic Society 31 (2011) 461-467.View Article
 
[10]  Kumar EM, Ramamurthy K. Influence of production on the strength, density and water absorption of aerated geopolymer paste and mortar using Class F fly-ash. Construction and Buildings Materials 156 (2017) 1137-1149.View Article
 
[11]  Kamseu E., Nait-Ali B., Bignozzi MC, Leonelli C., Rossignol S., DS Smith. Bulk composition and microstructure dependence of effective thermal conductivity of porous inorganic polymer cements. Journal of the EuropeanCeramic Society 32 (2012) 1593-1603.View Article
 
[12]  Font A., Borrachero MV, Soriano L., Monzó José., Payá J. Geopolymer eco-cellular (GECC) based on fluid catalytic cracking catalyst residue (FCC) with addition of recycled aluminum foil powder. Journal of Cleaner Production 168 (2017) 1120-1131.View Article
 
[13]  Luna-Galiano Y., Leiva C., Arenas C., Fernandez-Pereira C. Fly ash-based geopolymeric foams using silica fume as pore generation agent. Physical, mechanical and acoustic properties. Journal of Non-crystalline Solids 500 (2018) 196-204.View Article
 
[14]  Novais RM, Buruberri LH, Ascensao G., Seabra, MP, Labrincha JA Porous biomass fl y ash-based geopolymers with tailored thermal conductivity. Journal of Cleaner Production 119 (2016) 99-107.View Article
 
[15]  Cilla, MS, Morelli, MR, Colombo, P. Open cell geopolymer foams by a novel saponification / peroxide / gel casting combined route. Journal of the EuropeanCeramic Society 34 (2014) 3133-3137.View Article
 
[16]  Vaou V., Panias D. Thermal insulating foamy geopolymers from perlite. Minerals Engineering 23 (2010) 1146-1151.View Article
 
[17]  Abdollahnejad Z., Pacheco-Torgal F., Félix T., Tahri W., Aguiar JB Mix design, properties and cost analysis of fly ash-based geopolymer foam. Construction and Building Materials 80 (2015) 18-30.View Article
 
[18]  Tchakouté KH, Elimbi A., Yanne E., Djangang CN Utilization of volcanic ash for the production of geopolymers cured at ambient temperature. Cement and Concrete Composites 38 (2013) 78-81.View Article
 
[19]  Zhang, Z., Provis, JL, Reid, A., Wang, H. Mechanical, thermal insulation, thermal resistance and acoustic absorption properties of geopolymer foam concrete. Cement and Concrete Composites 62 (2015) 97-105.View Article
 
[20]  Ngouloure ZNM, Nait-Ali B., Zekeng S., Kamseu E., Melo UC, Smith D., Leonelli C. Recycled natural wastes in metakaolin-based porous geopolymers for insulating applications. Journal of Building Engineering 3 (2015) 58-69.View Article
 
[21]  Bell JL, Kriven WM Preparation of ceramic foams from metakaolin-based geopolymer gels. Ceramics Engineering Science Procedure 29 (2009) 97-111.
 
[22]  Shiu, H.-S., Lin, K.-L., Chao, S.-J., Hwang, C.-L., Cheng, T.-W. Effects of foam agent on characteristics of thin-film transistor liquid crystal display waste glass-metakaolin-based cellular geopolymer. Environmental Progress SustainableEnergy 33 (2014) 538-550.View Article
 
[23]  Landi E., Medric V., Papa E., Dedecek J., Klein P., Benito P., Vaccari A. Alkali-banded ceramics tailored porosity. Applied Clay Science 73 (2013) 56-64View Article
 
[24]  Sasmal N., Garai M., Karmakar B. Preparation and characterization of novel foamed porous glass ceramics. Materials Characterization 103 (2015) 90-100.View Article
 
[25]  Fernandes, HR, Ferreira, DD, Andreola, F., Lancellotti, I., Barbieri, L., Ferreira, JMF: Environmental friendly management of CRT glass by foaming with waste egg shells, calcite or dolomite. Ceramics International 40 (2014) 13371-13379.View Article
 
[26]  Gualtieri LM, Romagnoli M., Gualtieri FA Preparation of phosphoric acid-based geopolymer foams using limestone as pore forming agent. Thermal properties by in situ XRPD and Rietveld refinements. Journal of the European Ceramic Society 35 (2015) 3167-3178.View Article
 
[27]  Department of Geology and Mines 1979. http://www.worldcat.org/title/carte-geologique-de-reconnaissance-du-cameroun-garoua-ouest/oclc/81788746&referer=brief_results. 15-09-2017.
 
[28]  Laurie Bourgeois. Clay minerals. Polytech, Paris UPMC. P15, 2015.
 
[29]  Sobgwi TE Contribution to the physico-chemical and mineralogical study of materials from the Mayouom clay deposit (West Cameroon): Case of materials from well number 1. Magister'sthesis, University of Yaoundé I, P64, 2005.
 
[30]  Maglione G., Carn M. Infrared spectra of saline minerals and neoformed silicates in the Chad basin. Cah. ORSTOM, Geol., Vol.VII, P3-9, 1975.
 
[31]  Wetshondo Osomba. Characterization and valuation of clay materials from the Province of Kinshasa (DR Congo). Doctoral thesis, University of Liège, Architecture, Geology, 2012.
 
[32]  Bashir ASM, Manusamy Y. Characterization of Raw Egg Shell Powder (ESP) as A Good Bio-filler. Journal of Engineering Research and Technology 2 (2016).
 
[33]  Freire MN, Holanda JNF Characterization of avian eggshell waste aiming its use in ceramic wall tile paste. Ceramica 52 (2006) 240-244.View Article
 
[34]  Anjaneyulu U., Sasikumar S. Bioactive nanocrystallinewollastonite synthesized by sol-gel combustion using eggshell waste as calcium source. Bulletin of Materials Science 37 (2014) 207-212.View Article
 
[35]  Hongxia G., Zhenping, Q., Peng, Q., Peng, Y., Suping C., Wei W. Crystallization of aragonite CaCO3 with complex structures. Advances Powder Technology 22 (2011) 777-783.View Article
 
[36]  Choudhary R., Koppala S., Swamiappan S. Bioactivity studies of calcium magnesium silicate prepared from eggshell waste by sol-gel combustion synthesis. Journal of AsianCeramic Society 3 (2015) 173-177.View Article
 
[37]  Fongang RTT, Pemndje J., Lemougna PN, Melo UC, Nanseu CP, Nait-Ali B., Kamseu E., Leonelli C. Cleaner production of the lightweight insulating composites Microstructure, pore network and thermal conductivity. Energy and Building 107 (2015) 113-122.View Article
 
[38]  Hassan HS, Abdel-Gawwad HA, Vásquez García SR, Israde-Alcántara I. Fabrication and characterization of thermally-insulating coconut ash-based geopolymer foam. Waste Management 80 (2018) 235-240.View Article  PubMed
 
[39]  Alghamdi H., Neithalath N. Novel synthesis of lightweight geopolymer matrices from fly ash through carbonate-based activation. Materials Today Communications 17 (2018) 266-267.View Article
 
[40]  Wongsa A., Sata, V., Nematollahi B., Sanjayan J., Chindaprasirt. P. Mechanical and thermal properties of lightweight geopolymer mortar incorporating crumb rubber. Journal of Cleaner Production 195 (2018) 1069-1080.View Article
 
[41]  Riyap HI, Bewa CN, Banenzoué C., Tchakouté HK, Rüscher CH, Kamseu E., Bignozzi MC, Cristina Leonelli. Microstucture and mechanical, physical and structural properties of sustainable lightweight metakaolin-based geopolymer cements and mortars employing rice husk. Journal of AsianCeramicSocieties 7 (2019) 199-212.View Article